1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18


Up one chapter


view larger image

Begin OCR Text:
P 1 8OO VOlVo vo_vo 2_l73 ii_,___ F__g. 3_. F______ng gnd _ap ove_ ge_e__o_ _a_i_ Fi9_ 33, Fitt_ing interlock balls and springs _ A = approK. Q mm (5/32 _) _ 5. Place the main shaft in the housing. Turn viously. that is to say, the centre end cap the rear couer so that the countershaFt should project about 4 mm (5/32 '') outside can be fitted. the face of the housing, see Fia. 32. 6. Turn the gearboK upside down. Fit the 9. GearboKes with ouerdrive . countershaft from the rear. Hold against __urn the cover correctly so that it locks the SVO 23O3 with the hand. Ensure that the reverse shaft (early prod.) . Ensure that the thrust washers do not loosen and fall down. eccentric for the overdrive oiI pump is 7. Gearboxes without overdrive . turned upwards. Fit the overdrive unit. Turn the rear couer correctIy so that it Iocks Use new washers for the spacer fIange. the reverse shaft (early prod.) . Fit the bolts 1 O. PIace the i nterlock balls and springs in for the cover. position, see F_ig. 32. Fit the gearboK cover. 8. Fit selector rails and forks. Move over the Check that all gears engage and disengage _ selector fork to the rear position when freely. _ _ fitting the pin. use a new pin. Fit the casing _ ouer the selector raiIs. F___ _ _ote. _f the end caps _n thg front end of G the housing have been remoued, these Fitting is done in the reverse order to removing. _ should be fitted in the same way as pre- Fill up the gearboK with oil. 4 - 9
 
Not associated with Volvo AB Sweden or Volvo Cars of North America